- Notes, cautions, and warnings
- Introduction to this guide
- Planning an upgrade
- Completing pre-upgrade tasks
- Pre-upgrade process - Overview
- Collect cluster information
- Check cluster readiness
- Verify configurations and settings
- Download the OneFS installation bundle file
- Upgrade compatibility check utility
- On-Cluster Analysis tool
- HealthCheck tool
- Backup data
- Complete or stop jobs in progress
- Update Node Firmware Package
- Update Drive Support Package
- Configure IPMI ports
- Disable SupportAssist or Secure Remote Services (SRS)
- Performing the OneFS upgrade
- Upgrade process overview
- Completing a parallel upgrade of OneFS
- Completing a rolling upgrade of OneFS
- Completing a simultaneous upgrade of OneFS
- Adding a node to the cluster while an upgrade is in progress
- Committing an upgrade of OneFS
- Rolling back an upgrade of OneFS
- Verify the OneFS installation using the CLI
- Completing post-upgrade tasks
- Troubleshooting your upgrade
PowerScale OneFS Upgrade Planning and Process Guide
Commit an upgrade using the CLI
You can use the command-line interface to commit an upgrade of
OneFS. Once you commit the upgrade, you cannot roll back to the previous version of
OneFS.
- Open a secure shell (SSH) connection on the lowest-numbered node in the cluster and log in with the root account.
-
To commit the upgrade, run the following command:
isi upgrade cluster commit
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\