- Notes, cautions, and warnings
- Introduction
- Software
- Protocols
- Hardware
- Node Service and Support Life-cycle Dates
- OneFS and Node Compatibility
- Node Pool Compatibility
- Node and Drive Compatibility
- Node Firmware Package (NFP)
- Drive Support Package (DSP)
- Internal Network Switches and Life-cycle Dates
- CX6 100 GbE NIC and supported OneFS versions
- PowerScale nodes NICs and Transceivers
- Generation 6 NICs and Transceivers
- Generation 5 NICs and Transceivers
- Cloud Platforms
PowerScale OneFS Supportability and Compatibility Guide
SNMP
OneFS supports the Simple Network Management Protocol (SNMP). This section lists the compatible versions of SNMP and OneFS.
Simple Network Management Protocol (SNMP) is a protocol for network management. Use SNMP to remotely monitor hardware components (for example, fans, hardware sensors, power supplies, and disks) and software or subsystems for network-connected devices (for example, network interfaces, servers, switches, and CPU use). You can enable SNMP monitoring on individual nodes on your cluster. You can also monitor cluster information from any node.
For information about how to configure SNMP for OneFS, see the OneFS Administration Guide on the PowerScale OneFS Info Hub.
| SNMP | OneFS Compatibility | |||
|---|---|---|---|---|
| 8.1.x | ||||
| SNMP 2c | ✓ | |||
| SNMP 3 | ✓ | |||
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\