Connect to a virtual node through SSH
You can connect to a virtual node through SSH and manage a virtual cluster.
Ensure that the ext-1 interface is set to bridged before you proceed.
-
Open an SSH client and type the lowest IP address from the external range.
-
Log in with the root username and password.
-
At the command prompt, type the required
isi commands to monitor and manage your virtual cluster.
For example, type the following command at the command prompt to monitor the health and performance of the virtual cluster:
isi status
NOTE:OneFS supports tab completion. When typing an
isi command, you can press the TAB key to identify or complete the command syntax.
For more information about the OneFS commands, see the
OneFS CLI Administration Guide at
Dell Online Support.