You can use the
RESTORE_OPTIONS environment variable to specify a serial (single-threaded) restore operation.
In your data management application, configure a restore operation as you normally would.
Make sure that the
RESTORE_OPTIONS environment variable is set to
1 on your data management application.
If the
RESTORE_OPTIONS environment variable is not already set to
1, specify the
isi ndmp settings variables modify command from the
OneFS command line. The following command specifies serial restore for the
/ifs/data/projects directory:
The value of the
path option must match the
FILESYSTEM environment variable that is set during the backup operation. The value that you specify for the
name option is case sensitive.
Start the restore operation.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\