You can use NetWorker to recover data that you backed up previously.
This procedure describes the recovery operation that you can perform through NetWorker 9.0. If you are running a previous version of NetWorker, see the vendor documentation for instructions.
Connect to the NetWorker server from the NetWorker Management Console Server.
On the
Enterprise tab, select an enterprise—for example,
nw-win-1—and double-click.
Click
Launch NetWorker Administration.
In the NetWorker administration window, click the
Recover tab.
Click
Recover > New Recover.
In the
Recover Configuration window, specify the following settings:
In the
Select the Recovery Hosts screen, specify the following settings and click
Next.
In the
Source Host area, type the name or IP address of the source host with the backed data.
In the
Destination Host area, specify whether you want to recover data to the same host or specify a new destination host name or IP address.
In the
Select the Data to Recover screen, specify the following settings and click
Next.
Click the
Browse tab and select a date and time through which you want to recover data.
Browse and select the data to recover.
In the
Select the Recovery Options screen, specify the file path for recovery and click
Next.
In the
Obtain the Volume Recovery screen, select
Allow NetWorker to select the required volumes for recovery (Recommended) and click
Next.
In the
Perform the Recovery screen, specify a recovery name, recovery start time, and click
Run Recovery.
Check the results of the recovery operation through the
Check the Recovery Results screen.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\