You can create a replication policy with SyncIQ that defines how and when data is replicated to another
PowerScale cluster. Configuring a replication policy is a five-step process.
Configure replication policies carefully. If you modify any of the following policy settings after the policy is run, OneFS performs either a full or differential replication the next time the policy is run:
Source directory
Included or excluded directories
File-criteria statement
Target cluster name or address
This applies only if you target a different cluster. If you modify the IP or domain name of a target cluster, and then modify the replication policy on the source cluster to match the new IP or domain name, a full replication is not performed.
Target directory
NOTE:If you create a replication policy for a SmartLock directory, the SyncIQ and SmartLock compliance domains must be configured at the same root level. A SmartLock compliance domain cannot be nested inside a SyncIQ domain.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\