If you are backing up data to tape devices connected to one or more Backup Accelerator nodes or Fibre Attached Storage nodes, you must configure Veritas NetBackup to recognize those storage devices.
This procedure is required only if you are performing a two-way NDMP backup.
In the
NetBackup Administration Console, click
Media and Device Management.
Click
Configure Storage Devices.
The
Device Configuration Wizard appears.
Click
Next.
Scan the cluster for attached NDMP devices.
On the
Device Hosts page, click
Change.
Select
NDMP Host, and then click
OK.
Click
Next.
Select the NDMP host that you created earlier, and then click
Next.
After the wizard completes the scan for devices on the cluster, click
Next.
On the
SAN Clients page, click
Next.
Specify backup devices that NetBackup should use.
On the
Backup Devices page, verify that all attached tape devices are displayed in the table, and then click
Next.
On the
Drag and Drop Configuration page, Select the tape devices that you want NetBackup to backup data to and then click
Next.
In the confirmation dialog box, click
Yes.
On the
Updating Device Configuration page, click
Next.
On the
Configure Storage Units page, view the name of your storage unit and then click
Next.
Click
Finish.
Specify the storage unit to associate with the backup devices.
Expand
NetBackup Management.
Expand
Storage.
Click
Storage Units.
Double-click the name of the storage unit that you created previously.
In the
Change Storage Unit window, ensure that
Maximum concurrent write drives is equal to the number of tape drives connected to your cluster.
A storage unit is created for your cluster and tape devices. You can view all storage units by clicking
Storage Units.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\