With CommVault Simpana, you must add a NAS client for an
PowerScale cluster before you can back up data from the cluster.
In the
CommCell Browser, right-click
Client Computers, and then click
New Client > File System > NAS.
In the
Add NDMP Server window, configure the following settings:
Table 1. Setting SpecificationsThe following table displays the specifications for each setting.
Setting name
Setting value
NDMP Server Hostname
The cluster that you want to back up data from.
If you have a single Backup Accelerator node or Fibre Attached Storage node in the cluster, type the fully qualified domain name, or the host name, or the IPv4 or IPv6 address of the Backup Accelerator node or Fibre Attached Storage node.
If you have multiple Backup Accelerator nodes or Fibre Attached Storage nodes in the cluster, type the name of a SmartConnect zone that contains only the Backup Accelerator nodes or Fibre Attached Storage nodes.
If you are performing a three-way NDMP backup, type the fully qualified domain name, host name, SmartConnect zone, and the IPv4 or IPv6 address of any node in the cluster.
NDMP Login
The name of the NDMP user account that you configured on the
PowerScale cluster.
NDMP Password
The password of the NDMP user account that you configured on the
PowerScale cluster.
Listen Port
The number of the port through which data management applications (DMAs) can connect to the cluster. This field must match the Port number setting on the
PowerScale cluster. The default Port number on the
PowerScale cluster is 10000.
Detect MediaAgent
If your Simpana server is located on a different host machine, select the media agent client name from this drop-down menu.
Click
Detect.
The system populates the
Vendor and
Firmware Revision fields.
Click
OK.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\