You must add an
PowerScale cluster as an NDMP host before you can back up data with Symantec NetBackup.
Create an NDMP user account.
In the
NetBackup Administration Console, expand
Media and Device Management.
Under
Media and Device Management, expand
Credentials, and then click
NDMP Hosts.
Click
Actions > New > NDMP Host.
In the
NDMP Host Name dialog box, specify the cluster that you want to back up data from.
If you have a single Backup Accelerator or a Fibre Attached Storage node in the cluster, type the fully qualified domain name, host name, and the IPv4 or IPv6 address of the Backup Accelerator node or Fibre Attached Storage node.
If you have multiple Backup Accelerator nodes or Fibre Attached Storage nodes in the cluster, type the name of a SmartConnect zone that contains only the Backup Accelerator nodes or Fibre Attached Storage nodes.
If you are performing a three-way NDMP backup, type the fully qualified domain name (FQDN), host name, SmartConnect zone, and the IPv4 or IPv6 address of any node in the cluster.
Click
OK.
In the
Add NDMP Host box, click
Use the following credentials for this NDMP host on all media servers.
In the
Username and
Password fields, type the user name and password of an NDMP user on the cluster.
Click
OK.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\