You can back up data stored on
PowerScale clusters to another
PowerScale cluster or a tape device.
The SyncIQ software module enables you to replicate data to an
PowerScale cluster and recover the backed up data through the failover and failback processes. Failover enables you to access data on the cluster it was backed up to. After you fail over, you can fail back to resume accessing your data on the cluster it was backed up from.
NDMP enables you to backup data to a tape device and recover the backed up data to any
PowerScale cluster. NDMP tape block sizes of 512 KB are supported. Dell EMC PowerScale
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\