If you connect a tape device or media changer to a Fibre Attached Storage node, you must configure
OneFS to detect the device. Only then can
OneFS back up data to and restore data from the device. In
OneFS, you can scan a specific
PowerScale node, a specific port, or all ports on all nodes.
Click
Data Protection > NDMP > Devices.
Click the
Discover Devices link.
The
Discover Devices dialog appears.
Optional: To scan only a specific node for NDMP devices, from the
Node list, select a node.
Optional: To scan only a specific port for NDMP devices, from the
Ports list, select a port.
If you specify a port and a node, only the specified port on the node is scanned. However, if you specify only a port, the specified port will be scanned on all nodes.
Optional: To remove entries for devices or paths that have become inaccessible, select the
Delete inaccessible paths or devices check box.
Click
Submit.
For each device that is detected, an entry is added to either the
Tape Devices or
Media Changers tables.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\