You must create a NetBackup policy that specifies how you want to back up data from anPowerScale cluster.
In the
NetBackup Administration Console, expand
Media and Device Management.
Expand
Policies.
Right-click
Summary of all Policies, and then click
New Policy.
In the
Policy name field, type a name for the policy and then click
OK.
Configure the following settings:
NOTE: Refer to the
NetBackup documentation to understand how to enable and use multistreaming.
Setting name
Setting value
Notes
Policy Type
NDMP
Required
Policy volume pool
The name of the volume pool you created
Required
Allow multiple data streams
Selected
Optional. Enables multistreaming. It is recommended that you enable multistreaming whenever possible to increase the speed of backups.
Clients
The
PowerScale cluster you want to backup data from
Required
Backup Selections
The full path of a directory on the cluster that you want to backup
Required
set DIRECT=Y
Optional. Enables direct access restore (DAR) for the directory. It is recommended that you enable DAR for all backups.
set HIST=F
Optional. Specifies path-based file history. It is recommended that you specify path-based file history for all NetBackup backups.
set NEW_STREAM
The full path of a directory on the cluster that you want to backup
Optional. Backs up the specified directory on another stream. It is recommended that you enable multistreaming whenever possible to increase the speed of backups.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\