You can view file system events and event service rates within the File System Performance report.
For this example, you are researching into a particular date range when the OneFS cluster behaved unexpectedly and determine what might have been the cause.
Click the
Performance Reporting tab.
On the
Live Performance Reporting page, click the
Cluster drop down and select the cluster that you want to monitor.
Click the
Report Type drop down and select
File System Performance.
In the
Date Range fields, select a range to display, then click
View Report.
The date range should include the entire period of time when the cluster was behaving unexpectedly. The default setting is to view the last hour of data.
The modules in the report are now populated with data for the cluster and date range you selected.
In the
File System Events Rate module, click the
Node breakout.
To remove focus on a breakout, click the
None breakout.
On the left side of the module, you can now see a list of all nodes that were interacting with the file system during the date range you specified. The node at the top of the list had the highest percentage of file system events.
Select the Node with the highest percentage of file system events.
In the
File System Events Rate module, click the
FS Event breakout.
On the left side of the module, you can now see a list of all file system events that the selected node was sending and receiving during the date range you specified. The event at the top of the list was the most active.
With the information you gathered, you can determine which node is servicing the most events and the rate of those events that might be causing performance issues on the cluster.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\