- Notes, cautions, and warnings
- Introduction to this guide
- Configuration
- Configuration and setup overview
- Configuring the InsightIQ system settings
- Configuring File System Analytics job settings
- Configuring datastores
- Setting up data sets
- Setting up user accounts
- Configuring LDAP for authentication
- Configuring cluster monitoring
- Configuration and setup overview
- InsightIQ commands
- Troubleshooting InsightIQ
Dell InsightIQ 4.3.0.0 Administration Guide
Setting up user accounts
Create and delete user accounts.
A user account allows anyone to log in to the InsightIQ web application and monitor cluster activity. A read-only user account cannot modify InsightIQ configuration settings, create performance reports, or add user accounts.
NOTE: An LDAP user may be granted administrator access based on the LDAP group configuration.
During the InsightIQ setup process, the administrator account is configured. The administrator account can create, modify, and delete user accounts. There is only one administrator account per installation of InsightIQ. There is no limit to the number of user accounts.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\