Configure InsightIQ to monitor a PowerScale OneFS or Isilon OneFS cluster.
Prerequisites
The monitored cluster must meet the following prerequisites:
The OneFS cluster must have a local user account named "insightiq"
The "insightiq" user account must be within the System Zone.
About this task
To begin monitoring a cluster, follow these steps:
Steps
In the InsightIQ web application, click the
Settings tab and then
Monitored Clusters on the
Settings ribbon, and then click
Add Cluster.
NOTE: The first time that you configure InsightIQ, the
Add Cluster dialog box might already be displayed by default.
In the
Add Cluster dialog box, in the
Isilon cluster address field, type the hostname, SmartConnect zone name, or IP address of any node in the cluster that you want to monitor.
In general, it is recommended that you specify a cluster by a SmartConnect zone that includes CPU load-balancing policies. Alternatively, for clusters with high usage and file-heat data, you might want to specify the cluster by the IP address or by the hostname of a specific node.
NOTE: It is recommended that you monitor clusters over a LAN connection. Monitoring clusters over a WAN connection can significantly degrade the performance of InsightIQ.
NOTE: Specify IPv6 addresses without surrounding brackets. You can connect over IPv6 only if IPv6 addresses are configured for both the InsightIQ instance and the monitored cluster.
In the
InsightIQ user name field, type
insightiq.
In the
InsightIQ user password field, type the password of the OneFS cluster's
insightiq local user account.
Click
OK.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\