- Notes, cautions, and warnings
- Introduction to this guide
- Configuration
- Configuration and setup overview
- Configuring the InsightIQ system settings
- Configuring File System Analytics job settings
- Configuring datastores
- Setting up data sets
- Setting up user accounts
- Configuring LDAP for authentication
- Configuring cluster monitoring
- Configuration and setup overview
- InsightIQ commands
- Troubleshooting InsightIQ
Dell InsightIQ 4.3.0.0 Administration Guide
Enable or disable retrieval of data sets
Enable or disable the retrieval of data in InsightIQ.
About this task
NOTE: After you enable retrieval of a data set, InsightIQ begins retrieving the most recent data for that data set. InsightIQ does not recover data for the time that data retrieval was disabled. Affected modules display zero values for the period that data set retrieval was disabled.
Steps
-
In the InsightIQ web application, click the
Settings tab and then click
Monitored clusters on the
Settings ribbon.
The Monitored Clusters view appears and shows a list of all clusters that InsightIQ is configured to monitor.
- In the Actions column for the cluster that you want to modify, click Configure.
- Click Data Set Configuration.
- In the Actions column for the data set that you want to enable or disable, click enable or disable.
Results
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\