- Notes, cautions, and warnings
- Introduction to this guide
- Configuration
- Configuration and setup overview
- Configuring the InsightIQ system settings
- Configuring File System Analytics job settings
- Configuring datastores
- Setting up data sets
- Setting up user accounts
- Configuring LDAP for authentication
- Configuring cluster monitoring
- Configuration and setup overview
- InsightIQ commands
- Troubleshooting InsightIQ
Dell InsightIQ 4.3.0.0 Administration Guide
Enable and disable FSA
Enables and disables the FSA job and reports.
About this task
To view and analyze File System reports with InsightIQ, enable the FSA job.
Steps
- In the InsightIQ web application, click the Settings tab.
-
Click
Monitored Clusters on the
Settings ribbon.
The Monitored Clusters view appears and shows a list of all clusters that InsightIQ is configured to monitor.
-
In the
Actions column of the cluster that you want configure, click
Configure.
The Cluster Credentials view appears.
-
Click the
Enable FSA tab.
The Job Control view appears.
-
To enable or disable whether you can view File System Analytics reports in InsightIQ, and whether the cluster generates new reports, select or clear the checkboxes.
- To configure the FSA job, select or clear the Generate FSA reports on the monitored cluster checkbox.
- To configure InsightIQ for File System Analytics reports, select or clear the View FSA reports in InsightIQ checkbox.
- Click Submit.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\