- Notes, cautions, and warnings
- Introduction to this guide
- Configuration
- Configuration and setup overview
- Configuring the InsightIQ system settings
- Configuring File System Analytics job settings
- Configuring datastores
- Setting up data sets
- Setting up user accounts
- Configuring LDAP for authentication
- Configuring cluster monitoring
- Configuration and setup overview
- InsightIQ commands
- Troubleshooting InsightIQ
Dell InsightIQ 4.3.0.0 Administration Guide
Delete an InsightIQ datastore
Permanently stop InsightIQ monitoring on a cluster and delete all historical data about the cluster's performance.
About this task
CAUTION: If you delete the InsightIQ monitoring configuration for a cluster, all historical data for that cluster is deleted. You cannot undo a deletion.
As an alternative to deleting the InsightIQ monitoring configuration and all associated data, you can temporarily suspend monitoring of the cluster and then resume monitoring at a later time.
Steps
-
In the InsightIQ web application, click the
Settings tab and then
Monitored Clusters on the
Settings ribbon.
The Monitored Clusters view appears and shows a list of all clusters that InsightIQ is configured to monitor.
-
In the
Actions column of the cluster configuration that you want to delete, click
Delete.
A Remove Cluster dialog box appears.
- Click OK.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\