- Notes, cautions, and warnings
- Introduction
- Upgrade the PowerProtect DP Series Appliance
- Supported upgrade paths
- Prerequisites
- Upgrade the PowerProtect DP Series Appliance
- Upgrade the external VM Proxy
- Update Storage Pool HCL database (applicable for DP5900 model only)
- Upgrade Cyber Recovery for DP4400 and DP5900
- Upgrade from SRS to SCG
- Troubleshoot upgrade validation and upgrade failures
- Troubleshoot Upgrade Validation failures
- Unable to access the ACM UI during appliance upgrade
- Protection Storage
- Used capacity of the / partition on Search exceeds 55 percent
- Used capacity of the partitions other than the / partition on Search exceeds 90 percent
- Protection Software
- Reporting and Analytics
- Data Protection Central
- Cloud DR
- ACM, Hypervisor Manager, and Hypervisor
- Troubleshoot Upgrade failures
- Possible errors with firmware upgrade
- Manual upgrade of PowerProtect DP Series Appliance Server Firmware
- Troubleshoot Upgrade Validation failures
- Network ports
- Protection Software
- Utility node required inbound ports
- Storage node required inbound ports
- Protection Software client required inbound ports
- Protection Software Downloader Service host required inbound port
- Required ports when using a Protection Storage system
- NDMP accelerator node required inbound ports
- Remote management interface inbound ports
- Protection Software VMware Combined Proxy inbound ports
- Inbound ports for the Azure network security group
- Protection Storage
- Data Protection Central
- Search
- Reporting & Analytics
- Secure Connect Gateway
- Remote server management (iDRAC)
- Cloud DR
- Cyber Recovery
- Protection Software
Dell EMC PowerProtect DP Series Appliance 2.7.7 Upgrade Guide for DP4400 and DP5900
Prerequisites
This section lists the prerequisites for upgrading the Cyber Recovery component.
- Ensure that the appliance is successfully upgraded.
- Check the supported Cyber Recovery software upgrade paths and note the version that you want to upgrade to.
- Download the following
Cyber Recovery binaries for the required version from the
Dell Support:
- PowerProtect Cyber Recovery software
- PowerProtect Cyber Recovery Virtual Appliance OS security patch
- Ensure that admin user is created in Cyber Recovery. If admin user is not present, create an admin user by accessing from the Cyber Recovery UI.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\