- Notes, cautions, and warnings
- Introduction
- Upgrade the PowerProtect DP Series Appliance
- Supported upgrade paths
- Prerequisites
- Upgrade the PowerProtect DP Series Appliance
- Upgrade the external VM Proxy
- Update Storage Pool HCL database (applicable for DP5900 model only)
- Upgrade Cyber Recovery for DP4400 and DP5900
- Upgrade from SRS to SCG
- Troubleshoot upgrade validation and upgrade failures
- Troubleshoot Upgrade Validation failures
- Unable to access the ACM UI during appliance upgrade
- Protection Storage
- Used capacity of the / partition on Search exceeds 55 percent
- Used capacity of the partitions other than the / partition on Search exceeds 90 percent
- Protection Software
- Reporting and Analytics
- Data Protection Central
- Cloud DR
- ACM, Hypervisor Manager, and Hypervisor
- Troubleshoot Upgrade failures
- Possible errors with firmware upgrade
- Manual upgrade of PowerProtect DP Series Appliance Server Firmware
- Troubleshoot Upgrade Validation failures
- Network ports
- Protection Software
- Utility node required inbound ports
- Storage node required inbound ports
- Protection Software client required inbound ports
- Protection Software Downloader Service host required inbound port
- Required ports when using a Protection Storage system
- NDMP accelerator node required inbound ports
- Remote management interface inbound ports
- Protection Software VMware Combined Proxy inbound ports
- Inbound ports for the Azure network security group
- Protection Storage
- Data Protection Central
- Search
- Reporting & Analytics
- Secure Connect Gateway
- Remote server management (iDRAC)
- Cloud DR
- Cyber Recovery
- Protection Software
Dell EMC PowerProtect DP Series Appliance 2.7.7 Upgrade Guide for DP4400 and DP5900
NDMP accelerator node required inbound ports
This section describes the inbound ports that must be accessible to network packets that are sent to each Protection Software accelerator node.
The following table describes the inbound ports that must be accessible to network packets that are sent to each Protection Software accelerator node. For each row, the accelerator node is the destination and the source is listed in the Source computer column:
| Port | Protocol | Source | Additional information |
|---|---|---|---|
| 7543 | HTTP/SSL | Web browser clients | Web browser clients use this port to create HTTPS connections to Protection Software Installation Manager. Limit access to trusted administrator computers. |
| 28002-28202 | TCP | Protection Software client/agent | - |
| 30002-30202 | TCP | Protection Software client/agent | - |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\