- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Safety instructions
- Recommended tools
- System board components
- Screw list
- Removing the right-side cover
- Replacing the right-side cover
- Removing the front cover
- Replacing the front cover
- Removing the slim optical drive
- Replacing the slim optical drive
- Removing the light bar
- Replacing the light bar
- Removing the memory module
- Replacing the memory module
- Removing the front I/O-panel
- Replacing the front I/O-panel
- Removing the logo board
- Replacing the logo board
- Removing the front-panel light board
- Replacing the front-panel light board
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the 3.5-inch hard drive
- Replacing the 3.5-inch hard drive
- Removing the 2.5-inch hard drive
- Replacing the 2.5-inch hard drive
- Removing the fan
- Replacing the fan
- Removing the graphics card
- Replacing the graphics card
- Removing the VR heat sink
- Replacing the VR heat sink
- Removing the processor fan
- Replacing the processor fan
- Removing the heat sink
- Replacing the heat sink
- Removing the processor-cooling assembly
- Replacing the processor-cooling assembly
- Removing the processor
- Replacing the processor
- Removing the power-supply unit
- Replacing the power-supply unit
- Removing the top cover
- Replacing the top cover
- Removing the front bezel
- Replacing the front bezel
- Removing the power-button board
- Replacing the power-button board
- Removing the antenna
- Replacing the antenna
- Removing the left-side cover
- Replacing the left-side cover
- Removing the bottom cover
- Replacing the bottom cover
- Removing the rear cover
- Replacing the rear cover
- Removing the system board
- Replacing the system board
- BIOS setup program
- Flashing the BIOS
- Diagnostics
- Getting help and contacting Dell
Inspiron 5680 Service Manual
Procedure
- Align the graphics card with the slot on the chassis.
- Align and place the graphics card into the slot on system board and press down firmly until the graphics card snaps into place.
- Replace the two screws (6-32UNCx3.6) that secure the graphics card to the chassis.
- Align the tab on the graphics-card bracket to the slot on the chassis.
- Align the screw holes on the graphics-card bracket to the screw holes on the chassis and replace the two screws (6-32UNCx3.6) that secures the graphics-card bracket to the chassis.
- Connect the graphics-card cable to the graphics card.
- Place the computer in an upright position.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\