- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing coin-cell battery
- Removing and installing components
- Left-side cover
- Front cover
- Hard drive
- Hard-drive and optical-drive cage
- Optical drive (optional)
- Power button
- Memory
- Solid-state drive
- Wireless card
- Media-card reader (optional)
- Power supply unit
- Antenna modules
- Fan shroud
- Processor fan and heat-sink assembly
- Processor
- System board
- Recommended tools
- Screw list
- Major components of Inspiron 3020 Small Desktop
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 3020 Small Desktop Service Manual
Installing the fan shroud
CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
About this task
The following image indicates the location of the fan shroud and provides a visual representation of the installation procedure.
Steps
- Align the fan shroud over the processor fan.
NOTE:The side of the fan with the word 'REAR' written must face the rear of the chassis.NOTE:The stubs on the fan shroud must align to the corresponding stub holes on the processor fan.
- Press down on the fan shroud until all the securing tabs snap into position.
Next steps
- Install the left-side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\