Installing the 2.5-inch hard-drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following section provides steps for installing the 2.5-inch hard-drive assembly.
NOTE:You can install a total of 2 2.5-inch hard-drives onto the hard-drive cage.
Steps
-
Align the screw holes on the 2.5-inch hard-drive to the slots on the cage.
-
Insert the 2.5-inch hard-drive into the cage.
-
Replace the two (M3) screws that secure the 2.5-inch hard-drive to the cage.
-
Repeat steps 1 to 3 to install the second 2.5-inch hard-drive to its cage.
-
Locate the cavity on the chassis where the 2.5-inch hard-drive assembly is to be inserted.
-
Turn over the 2.5-inch hard-drive assembly vertically and align the hooks on the cage to the cavities on the chassis.
-
Pinch the top sides of the cage and insert the cage into the cavities on the chassis.
-
Connect the SATA cable and SATA power cable to its connectors on the hard-drive(s).
-
Route the SATA cable and SATA power cable through the routing guides on the chassis.