- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the stand
- Replacing the stand
- Removing the back cover
- Replacing the back cover
- Removing the hard drive
- Replacing the hard drive
- Removing the system-board shield
- Replacing the system-board shield
- Removing the memory module
- Replacing the memory module
- Removing the wireless card
- Replacing the wireless card
- Removing the antenna
- Replacing the antenna
- Removing the media-card reader
- Replacing the media-card reader
- Removing the power-button board
- Replacing the power-button board
- Removing the microphone
- Replacing the microphone
- Removing the camera
- Replacing the camera
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the fan
- Replacing the fan
- Removing the heat sink
- Replacing the heat sink
- Removing the speakers
- Replacing the speakers
- Removing the system board
- Replacing the system board
- Removing the display panel
- Replacing the display panel
- Removing the rubber feet
- Replacing the rubber feet
- Removing the middle frame
- Replacing the middle frame
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 24 3000 All-in-One Service Manual
Procedure
- Using the alignment post, align the screw hole on the power-button board with the screw hole on the display-assembly base.
- Replace the screw (M3x5) that secures the power-button board to the display-assembly base.
- Adhere the power-button board cable to the display-assembly base.
- Slide the power-button board cable into the connector on the system board and close the latch to secure the cable.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\