- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Technical overview
- Removing the stand assembly
- Replacing the stand assembly
- Removing the back cover
- Replacing the back cover
- Removing the optical drive
- Replacing the optical drive
- Removing the hard drive
- Replacing the hard drive
- Removing the memory modules
- Replacing the memory modules
- Removing the wireless card
- Replacing the wireless card
- Removing the heat sink
- Replacing the heat sink
- Removing the fan
- Replacing the fan
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the microphone
- Replacing the microphone
- Removing the camera
- Replacing the camera
- Removing the system board
- Replacing the system board
- Removing the VESA-mount bracket
- Replacing the VESA-mount bracket
- Removing the speaker cover
- Replacing the speaker cover
- Removing the speakers
- Replacing the speakers
- Removing the control-buttons board
- Replacing the control-buttons board
- Removing the display assembly
- Replacing the display assembly
- Removing the rubber feet
- Replacing the rubber feet
- Clearing Forgotten Passwords
- Clearing CMOS Settings
- Flashing the BIOS
- System diagnostic lights
- Getting help and contacting Dell
Inspiron 24 3000 Service Manual
Procedure
- Slide the control-buttons board cable into the connector on the control-buttons board and press down on the latch to secure the cable.
- Replace the control-buttons board into the slot on the display bezel.
- Route the control-buttons board cable through the routing guides and adhere the control-buttons board cable to the display-assembly base.
- Slide the control-buttons board cable into the connector on the systems board and press down on the latch to secure the cable.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\