Inspiron 16 7635 2-in-1 Owner's Manual

Installing the power button

CAUTION: The information in this section is intended for authorized service technicians only.

If you are replacing a component, remove the existing component before performing the installation process.

NOTE: This procedure applies only to computers shipped with a standard power button.

The following image(s) indicate the location of the power button and provides a visual representation of the installation procedure.

Installing the power button

Insert the power button into the slot on the palm-rest and keyboard assembly.
Align the screw holes on the power-button board with the screw holes on the palm-rest and keyboard assembly.
Replace the two screws (M2x3) that secure the power-button board to the palm-rest and keyboard assembly.
Connect the power-button board cable to the I/O board and close the latch.
Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and keyboard assembly.
Replace the two screws (M2.5x5) and the screw (M2x4) that secure the left display hinge to the palm-rest and keyboard assembly.