- Notes, cautions, and warnings
- Views of Inspiron 16 7635 2-in-1
- Set up your Inspiron 16 7635 2-in-1
- Specifications of Inspiron 16 7635 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Keyboard shortcuts of Inspiron 16 7635 2-in-1
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- Multiple display support matrix
- Operating and storage environment
- Dell Support policy
- ComfortView
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 16 7635 2-in-1 Owner's Manual
Installing the palm-rest and keyboard assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
About this task
NOTE: The replacement palm-rest and keyboard assembly comes pre-assembled with the following components.
- Keyboard
- Wireless antennas
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest and keyboard assembly.
NOTE: Brackets are required on the palm-rest and keyboard assembly for computer configuration with the 4-cell battery (64 Wh). If the palm-rest and keyboard assembly is replaced, transfer the brackets to the new palm-rest and keyboard assembly.
Next steps
- Install the touchpad.
- Install the display assembly.
- Install the speakers.
- Install the speaker board.
- Install the power button or the power button with fingerprint reader, whichever is applicable.
- Install the
system board.
NOTE: The system board can be replaced with the heat sink pre-attached.
- Install the I/O board.
- Install the coin-cell battery.
- Install the fan.
- Install the wireless card.
- Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive , whichever is applicable.
- Install the 4-cell battery (64 Wh) or the 6-cell battery (86 Wh), whichever is applicable.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\