- Notes, cautions, and warnings
- Views of Inspiron 16 7635 2-in-1
- Set up your Inspiron 16 7635 2-in-1
- Specifications of Inspiron 16 7635 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Keyboard shortcuts of Inspiron 16 7635 2-in-1
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- Multiple display support matrix
- Operating and storage environment
- Dell Support policy
- ComfortView
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 16 7635 2-in-1 Owner's Manual
Removing the speakers
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
The following images indicate the location of the speakers and provides a visual representation of the removal procedure.
Steps
- Using the pull tab, disconnect the speaker-board cable from the speaker board.
- Using the pull tab, disconnect the speaker-board cable from the system board.
- Remove the speaker-board cable from the routing guides on the palm-rest and keyboard assembly.
- Lift the latch and disconnect the touchpad cable from the system board.
- Lift the latch and disconnect the keyboard cable from the system board.
- Lift the latch and disconnect the keyboard-backlight cable from the system board.
- Disconnect the speaker cables from the connector on the system board.
- Remove the speaker cables from the routing guides on the palm-rest and keyboard assembly.
- Lift the left and right speakers along with their cables off the palm-rest and keyboard assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\