- Notes, cautions, and warnings
- Views of Inspiron 16 5635
- Set up your Inspiron 16 5635
- Specifications of Inspiron 16 5635
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Keyboard shortcuts
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Operating and storage environment
- Dell support policy
- ComfortView
- ComfortView Plus
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 16 5635 Owner's Manual
Removing the heat sink
Prerequisites
CAUTION:The information in this section is intended for authorized service technicians only.
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
NOTE:Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) indicate the location of the heat sink and provides a visual representation of the removal procedure.
Steps
- In reverse sequential order (4>3>2>1), loosen the four captive screws that secure the heat sink to the system board.
- Lift the heat sink off the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\