- Notes, cautions, and warnings
- Views of Inspiron 16 5635
- Set up your Inspiron 16 5635
- Specifications of Inspiron 16 5635
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Keyboard shortcuts
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Operating and storage environment
- Dell support policy
- ComfortView
- ComfortView Plus
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 16 5635 Owner's Manual
Installing the base cover
Prerequisites
About this task
NOTE:The following image(s) shows the base cover and provides a visual representation of the installation procedure.
Steps
- Ensure the battery cable has been connected to the system board.
- Place and snap the base cover into place on the palm-rest and keyboard assembly.
- Tighten the two captive screws on the base cover.
- Replace the seven screws (M2x4) to secure the base cover to the palm-rest and keyboard assembly.
Next steps
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\