- Notes, cautions, and warnings
- Views of Inspiron 16 5635
- Set up your Inspiron 16 5635
- Specifications of Inspiron 16 5635
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Keyboard shortcuts
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Operating and storage environment
- Dell support policy
- ComfortView
- ComfortView Plus
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 16 5635 Owner's Manual
Installing the display assembly
Prerequisites
CAUTION:The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the installation procedure.
Steps
- Place the display assembly on a clean and flat surface with the display panel facing up.
- Gently place the palm-rest and keyboard assembly under the display hinges.
- Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and keyboard assembly.
- Replace the two screws (M2.5x5) to secure the left display hinge to the palm-rest and keyboard assembly.
- Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the palm-rest and keyboard assembly.
- Replace the three screws (M2.5x5) to secure the right display hinge to the palm-rest and keyboard assembly.
- Connect the display cable to the system board and close the latch.
- Adhere the tape to secure the display-cable connector latch to the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\