- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of your system
- Base cover
- Battery
- WLAN card
- Memory modules
- Solid-state drive
- Removing the M.2 2280 solid-state drive (SSD-1)
- Installing the M.2 2280 solid-state drive (SSD-1)
- Removing the M.2 2230 solid-state drive (SSD-1)
- Installing the M.2 2230 solid-state drive (SSD-1)
- Replacing the SSD-1 support bracket
- Removing the M.2 2280 solid-state drive (SSD-2)
- Installing the M.2 2280 solid-state drive (SSD-2)
- Speakers
- GPU fan
- System fan
- Heat sink
- Coin-cell battery
- I/O board
- Power button with fingerprint reader (optional)
- DC-in port
- Touchpad
- Display assembly
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 7501 Service Manual
Removing the DC-in port
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the base cover.
About this task
The figure indicates the location of the DC-in port and provides a visual representation of the removal procedure.
Steps
- Remove the two screws (M2.5x5) and (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
- Open the left display hinge at an angle of 90 degrees.
- Disconnect the DC-in port cable from the system board.
- Remove the single screw (M2x3) that secures the DC-in port to the palm-rest and keyboard assembly.
- Lift the DC-in port, along with its cable, off the palm-rest and keyboard assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\