Place the I/O board on the palm-rest and keyboard assembly, and then align the screw holes on the I/O board with the screw holes on the
palm-rest and keyboard assembly.
Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
Slide the fingerprint-reader cable into the connector on the I/O board and
close the latch to secure the cable.
Slide the I/O-board cable into the connector on the I/O board and
close the latch to secure the cable.
Adhere the tape that secures the I/O-board cable to the palm-rest and keyboard assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\