Inspiron 15 5000 Service Manual

Procedure

NOTE: : Ensure that the hinges are opened to the maximum before replacing the display assembly on palm rest and keyboard assembly.

Slide the palm rest and keyboard assembly under the hinges on the display assembly and close it.
Using the alignment posts, press the hinges down on the system board and the palm rest and keyboard assembly.
Replace the five screws (M2.5x5) that secure the left and right hinges to the system board and palm rest and keyboard assembly.
NOTE: : For computers shipped without optical drive, there is an additional screw on the left hinge.
Route the display cable through the routing guides on the fan and the palm rest and keyboard assembly.
Slide the display cable to the connector on the system board and close the latch to secure the cable.
NOTE: : The following steps are applicable only for the computers that are shipped with optical drive.
Press down on the latch to connect the optical-drive connector board cable to the optical-drive connector board.
Press down on the latch to connect the optical-drive connector board cable to the system board.