- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the battery
- Replacing the battery
- Replacing the optical drive
- Removing the optical drive
- Removing the base cover
- Replacing the base cover
- Removing the memory modules
- Replacing the memory modules
- Removing the hard drive
- Replacing the hard drive
- Removing the wireless card
- Replacing the wireless card
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the keyboard
- Replacing the keyboard
- Removing the computer base
- Replacing the computer base
- Removing the optical-drive interposer
- Replacing the optical-drive interposer
- Removing the speakers
- Replacing the speakers
- Removing the I/O board
- Replacing the I/O board
- Removing the heat-sink assembly
- Replacing the heat-sink assembly
- Removing the power-button module
- Replacing the power-button module
- Removing the system board
- Replacing the system board
- Removing the display assembly
- Replacing the display assembly
- Removing the display bezel
- Replacing the display bezel
- Removing the display panel
- Replacing the display panel
- Removing the display hinges
- Replacing the display hinges
- Removing the display cable
- Replacing the display cable
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- Removing the camera
- Replacing the camera
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Flashing the BIOS
Inspiron 15 5000 Service Manual
Procedure
- Place the palm-rest assembly at the edge of the table with the coin-cell battery facing away from the edge.
- Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
- Replace the screws that secure the display hinges to the palm-rest assembly.
- Close the display and turn the computer over.
- Route the display cable through the routing guides on the palm-rest assembly.
- Slide the display cable to the connector and press down on the latch to connect the display cable to the system board.
- Route the antenna cable through the routing guides on the palm-rest assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\