- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 15 5502
- Base cover
- Battery
- Memory module
- Solid-state drive—M.2 slot one
- Solid-state drive—M.2 slot two
- Wireless card
- Fan
- Coin-cell battery
- Heat sink
- Display assembly
- Power-adapter port
- Speakers
- Power button with optional fingerprint reader
- Touchpad
- I/O board
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 15 5502 Service Manual
Removing the M.2 2230 solid-state drive from M.2 slot two
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
NOTE Depending on the configuration ordered, your computer may support an M.2 2230 solid-state drive or an M.2 2280 solid-state drive in M.2 slot two.
NOTE This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed in M.2 slot two.
The figure indicates the location of the M.2 2230 solid-state drive that is installed in M.2 slot two and provides a visual representation of the removal procedure.
Steps
- Remove the screw (M2x3) that secures the M.2 2230 solid-state drive to the palm-rest and keyboard assembly.
- Slide and lift the M.2 2230 solid-state drive off M.2 slot two on the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\