Power and battery-status light/hard-drive activity light
Indicates the battery-charge status or the hard-drive activity.
NOTE Press Fn+H to toggle this light between power and battery-status light and hard-drive activity light.
Hard-drive activity light
Turns on when the computer reads from or writes to the hard drive.
Power and battery-status light
Indicates the power and battery-charge status.
Solid white — Power adapter is connected and the battery has more than 5 percent charge.
Amber — Computer is running on battery and the battery has less than 5 percent charge.
Off
Power adapter is connected and the battery is fully charged.
Computer is running on battery and the battery has more than 5 percent charge.
Computer is in sleep state, hibernation, or turned off.
The power and battery-status light blinks amber along with beep codes indicating failures.
For example, the power and battery-status light blinks amber two times followed by a pause, and then blinks white three times followed by a pause. This 2,3 pattern continues until the computer is turned off indicating no memory or RAM is detected.
The following table shows the different power and battery-status light patterns and the problems that each light pattern indicates.
Camera status light: Indicates whether the camera is in use.
Solid white — Camera is in use.
Off — Camera is not in use.
Caps Lock status light: Indicates whether Caps Lock is enabled or disabled.
Solid white — Caps Lock enabled.
Off — Caps Lock disabled.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\