- Notes, cautions, and warnings
- Views of Inspiron 15 3535
- Set up your Inspiron 15 3535
- Specifications of Inspiron 15 3535
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Hardware security
- Operating and storage environment
- ComfortView
- Color, material, and finish
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 15 3535 Owner's Manual
Installing the power button with optional fingerprint reader
CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
About this task
The following images indicate the location of the power button with optional fingerprint reader and provide a visual representation of the installation procedure.
Steps
- Using the alignment posts, place the power button with fingerprint reader into its slot on the palm-rest and keyboard assembly.
- Replace the (M2x2) screw that secures the power button with fingerprint reader to the palm-rest and keyboard assembly.
- Adhere the tape to secure fingerprint reader Flexible Flat cable to the palm-rest and keyboard assembly.
NOTE: Fold and align the fingerprint reader Flexible Flat cable to the mark at the right of the power button, and align the white line on the Flexible Flat cable to the mark on the palm-rest and keyboard assembly.
Next steps
- Install the display assembly.
- Install the I/O board.
- Install the wireless card.
- Install the base cover.
- Install the SD card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\