- Notes, cautions, and warnings
- Views of Inspiron 15 3535
- Set up your Inspiron 15 3535
- Specifications of Inspiron 15 3535
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Hardware security
- Operating and storage environment
- ComfortView
- Color, material, and finish
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 15 3535 Owner's Manual
Installing the display assembly
CAUTION:The information in this section is intended for authorized service technicians only.
CAUTION:The maximum operating angle for the display-panel hinge is 135 degrees.
Prerequisites
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation procedure.
Steps
- Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
- Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
- Replace the four (M2.5x5) screws that secure the display hinges to the palm-rest and keyboard assembly.
- Route the WLAN antenna cables through the routing guides on the palm rest and under the speaker cable.
- Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE:Ensure to route the speaker cable over the WLAN antenna cables.
- Connect the display cable to the connector on the system board.
Next steps
- Install the wireless card.
- Install the base cover.
- Install the SD card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\