Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Inspiron 15 3535 Owner's Manual

Removing the display panel

CAUTION:The information in this section is intended for authorized service technicians only.
NOTE:This procedure is applicable for systems shipped with a plastic chassis only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SD card.
  3. Remove the base cover.
  4. Remove the wireless card.
  5. Remove the display assembly.
  6. Remove the hinge caps.
  7. Remove the display bezel.
  8. Remove the hinges.

About this task

The following images indicate the location of the display panel and provide a visual representation of the removal procedure.

Removing the display panel

Removing the display panel

Removing display panel

Steps

  1. Use a plastic scribe to pry the display panel from the bottom-right corner.

    Use a plastic scribe to pry the display panel from the bottom-right corner.

  2. Gently start prying the display panel along the right side of the display back-cover using your hand.

    Gently start prying the display panel along the right side of the display back-cover using your hand.

  3. Repeat step 1 and 2 for the left side of the display panel assembly.

    Repeat step 1 and 2 for the left side of the display panel assembly.

    Repeat step 1 and 2 for the left side of the display panel assembly.

  4. Lift the bottom side of the display panel and slide it downward to release the display brackets from the slots at the top side of the display cover.

    Lift the bottom side of the display panel and slide it downward to release the display brackets from the slots at the top side of the display cover.

  5. Gently flip the display panel assembly forward, peel back the Mylar tape securing the display cable on the rear of the display panel.
    NOTE:Ensure that the panel has a clean and smooth surface to rest on to prevent damage.
  6. Disconnect the display cable from the display panel assembly and lift the display panel away from the system.
    NOTE:For models shipped with plastic chassis, the diplay panel is assembled with the display brackets as a single service part. DO NOT pull the two pieces of elastic tape and separate the brackets from the panel.

    For models shipped with plastic chassis, the diplay panel is assembled with the display brackets as a single service part. DO NOT pull the two pieces of elastic tape and separate the brackets from the panel.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\