- Notes, cautions, and warnings
- Views of Inspiron 15 3535
- Set up your Inspiron 15 3535
- Specifications of Inspiron 15 3535
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Hardware security
- Operating and storage environment
- ComfortView
- Color, material, and finish
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 15 3535 Owner's Manual
Removing the display assembly
CAUTION:The information in this section is intended for authorized service technicians only.
CAUTION:The maximum operating angle for the display-panel hinge is 135 degrees.
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the SD card.
- Remove the base cover.
- Remove the wireless card.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- Remove the four (M2.5x5) screws that secure the display hinges to the palm-rest and keyboard assembly.
- Disconnect the display cable and the speaker cable from the system board (for systems with plastic chassis).
NOTE:Disconnect only the display cable from the system board for systems with aluminum chassis.
- Unroute the speaker cable from the routing guides on the palm-rest and keyboard assembly.
- Unroute the WLAN antenna cables from the routing guides on the palm-rest and keyboard assembly (for systems with plastic chassis).
- Open the display hinges at an angle of 90 degrees, and place the system on a flat surface.
- Remove the display assembly from the palm-rest and keyboard assembly.
NOTE:For systems with an aluminum chassis, the display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is removed from the bottom chassis. If any components in the display assembly malfunction and needs replacement, the entire display assembly has to be replaced.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\