- Notes, cautions, and warnings
- Views of Inspiron 15 3535
- Set up your Inspiron 15 3535
- Specifications of Inspiron 15 3535
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Hardware security
- Operating and storage environment
- ComfortView
- Color, material, and finish
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Inspiron 15 3535 Owner's Manual
Installing the system board
CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
About this task
The following image indicates the connectors on your system board.
- Fan connector
- I/O board FFC connector
- eDP connector
- DC-in port connector
- Memory modules
- Keyboard FFC connector
- Keyboard-backlight FFC connector
- Battery connector
- Touchpad FFC connector
- Wireless connector
- Speaker cable connector
- Solid-state drive connector
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
Steps
- Place the system board on the palm-rest and keyboard assembly.
- Align the screw holes on the system board with the screw holes on the palm-rest assembly.
- Replace the single (M2x2) screw that secures the system board to the palm-rest assembly.
- Replace the four (M2x3.5) screws that secure the system board to the palm-rest assembly.
- Connect the following cables to the system board:
- I/O board Flexible Flat cable
- Speaker cable
- Touchpad Flexible Flat cable
- Keyboard backlight Flexible Printed cable (for systems with backlit keyboard)
- Keyboard Flexible Printed cable
- Power adapter port cable
- eDP cable
- Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
- Replace the two (M2.5x5) screws to secure it to the palm-rest assembly.
Next steps
- Install the display assembly.
- Install the UMA heat sink or discrete heat sink, whichever applicable.
- Install the fan.
- Install the wireless card.
- Install the memory modules.
- Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive (whichever applicable).
- Install the 3-cell battery or 4-cell battery (whichever applicable).
- Install the base cover.
- Install the SD card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\