- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 15 3520
- Secure Digital (SD) Card
- Base cover
- Battery
- M.2 solid state drive
- Wireless card
- I/O board
- I/O daughter board FFC
- Hard drive assembly
- Memory module
- Speakers
- Heat sink
- Fan
- Power-button board
- Power button with fingerprint reader
- Display assembly
- Hinge caps
- Display bezel
- Hinges
- Display panel
- Camera module
- eDP cable
- Display cover and antenna assembly
- Touchpad
- System board
- Power-adapter port
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 15 3520 Service Manual
Installing the palmrest and keyboard assembly
Prerequisites
About this task
The following image indicates the location of the palmrest and keyboard assembly and provides a visual representation of the installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest and keyboard assembly.
Next steps
- Install the system board.
- Install the power button or power button with optional FPR.
- Install the power-adapter port.
- Install the display assembly.
- Install the touchpad.
- Install the hard drive assembly.
- Install the I/O board.
- Install the heat sink.
- Install the fan.
- Install the speakers.
- Install the wireless card.
- Install the memory modules.
- Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive (whichever applicable).
- Install the 3-cell battery or 4-cell battery (whichever applicable).
- Install the base cover.
- Install the SD card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\