- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 15 3520
- Secure Digital (SD) Card
- Base cover
- Battery
- M.2 solid state drive
- Wireless card
- I/O board
- I/O daughter board FFC
- Hard drive assembly
- Memory module
- Speakers
- Heat sink
- Fan
- Power-button board
- Power button with fingerprint reader
- Display assembly
- Hinge caps
- Display bezel
- Hinges
- Display panel
- Camera module
- eDP cable
- Display cover and antenna assembly
- Touchpad
- System board
- Power-adapter port
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 15 3520 Service Manual
Installing the display assembly
CAUTION:The maximum operating angle for the display-panel hinge is 135 degrees.
Prerequisites
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation procedure.
Steps
- Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
- Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
- Replace the four (M2.5x5) screws that secure the display hinges to the palm-rest and keyboard assembly.
- Route the WLAN antenna cables through the routing guides on the palm-rest and keyboard assembly. Adhere the tape to the heat sink and fan to secure the cables in place.
- Connect the display cable to the connector on the system board.
Next steps
- Install the wireless card.
- Install the base cover.
- Install the SD card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\