- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Inspiron 3505
- Base cover
- Battery
- Solid-state drive
- Wireless card
- I/O board
- Coin-cell battery
- Hard drive
- Memory modules
- Speakers
- Heat sink
- Fan
- Power button with optional fingerprint reader
- Fingerprint-reader board
- Display assembly
- Display bezel
- Display panel
- Camera
- Touchpad
- System board
- Power-adapter port
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 3505 Service Manual
Removing the fingerprint-reader board
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
NOTE:The fingeprint-reader board is an optional component and will only be installed in systems shipped with a fingerprint reader.
The following images indicate the location of the fingerprint-reader board and provides a visual representation of the removal procedure.
Steps
- Open the latch and disconnect the power-button cable from the fingerprint-reader board.
- Open the latch and disconnect the fingerprint-reader board cable from the fingerprint-reader board.
- Slide and remove the fingerprint-reader board from the securing clip on the palm-rest and keyboard assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\