Inspiron 3505 Service Manual

Installing the M.2 2230 solid-state drive

If you are replacing a component, remove the existing component before performing the installation process.

NOTE:This procedure applies if you are installing a M.2 2230 solid-state drive.

NOTE:The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:

The following images indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure.

Image: Installing the M.2 2230 solid-state drive

Place the M.2 2230 solid-state drive on the M.2 thermal shield.
Align the screw hole on the M.2 2230 solid-state drive to the screw mount on the M.2 thermal shield.
Replace the screw (M2x2) that secures the M.2 2230 solid-state drive to the M.2 thermal shield.
Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the system board.
Slide the M.2 2230 solid-state drive and M.2 thermal shield into the M.2 card slot on the palm-rest and keyboard assembly.
Align the screw holes on the M.2 thermal shield to the screw holes on the palm-rest and keyboard assembly.
Replace the screw (M2x2.2) that secures the M.2 thermal shield to the palm-rest and keyboard assembly.
Tighten the captive screw (M2x4) that secures the M.2 thermal shield to the palm-rest and keyboard assembly.