- Notes, cautions, and warnings
- Views of Inspiron 14 7445 2-in-1
- Set up your Inspiron 14 7445 2-in-1
- Specifications of Inspiron 14 7445 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- GPU—Integrated
- External display support
- Operating and storage environment
- Dell support policy
- ComfortView
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
Inspiron 14 7445 2-in-1 Owner's Manual
Installing the speakers
CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
About this task
Steps
- Using the alignment posts and rubber grommets, place the speakers on the slots of the palm-rest and keyboard assembly.
- Route the speaker and wireless module cables through the routing guides on the palm-rest and keyboard assembly.
NOTE:After replacing the speakers on the palm-rest and keyboard assembly, ensure that the rubber grommets are seated into the slot and installed on the speakers properly.
- Connect the speaker cable to the speaker-cable connector (SPK1) on the system board.
- Connect the touchpad cable to the touchpad-cable connector (TP1) on the system board and close the latch.
- Connect the keyboard cable to the keyboard-cable connector (KB1) on the system board and close the latch.
- Connect the keyboard-backlight cable to the keyboard-backlight cable connector (KBBL1) on the system board and close the latch.
Next steps
- Install the wireless card.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\