- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 14 7420 2-in-1 Service Manual
Removing the M.2 2230 solid-state drive
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
NOTE:The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
- M.2 2230 solid-state drive + 2230 mounting bracket
- M.2 2280 solid-state drive
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal procedure.
Steps
- Remove the screw (M2x3) that secures the M.2 2230 mounting bracket to the palmrest and keyboard assembly.
- Slide and lift the M.2 2230 solid-state drive and its mounting bracket from the M.2 card slot on the system board.
- Flip over the M.2 2230 solid-state drive and mounting bracket.
- Remove the screw (M2x2) that secures the M.2 2230 solid-state drive to the mounting bracket.
- Lift the M.2 2230 solid-state drive off the mounting bracket.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\