- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 7400 Service Manual
Installing the M.2 2280 solid-state drive/Intel Optane H10
Prerequisites
About this task
NOTE This procedure applies if you are installing a M.2 2280 solid-state drive/Intel Optane H10.
NOTE Depending on the configuration ordered your computer may support the following M.2 cards in the M.2 card slot:
- M.2 2230 solid-state drive + 2230 mounting bracket
- M.2 2280 solid-state drive
- M.2 2280 Intel Optane H10
The following images indicate the location of the M.2 2280 solid-state drive/Intel Optane H10 and provides a visual representation of the installation procedure.
Steps
- Lift the Mylar that covers the system board.
- Align the notch on the M.2 2280 solid-state drive/Intel Optane H10 with the tab on the M.2 card slot on the system board.
- Slide the M.2 2280 solid-state drive/Intel Optane H10 into the M.2 card slot on the system board.
- Replace the screw (M2x2.5) that secures the M.2 2280 solid-state drive/Intel Optane H10 to the palm-rest and keyboard assembly.
- Adhere the thermal tape that covers the M.2 2280 solid-state drive/Intel Optane H10.
- Place the Mylar over the M.2 2280 solid-state drive/Intel Optane H10.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\