Inspiron 5485 Service Manual

Procedure

1. Slide the palm-rest and keyboard assembly at an angle under the hinges on the display assembly.
   
2. Align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
3. Replace the four screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
4. Route the antenna cables along the routing guides on the fan.
   
5. Slide the display cable into the connector on the system board and close the latch to secure the cable.
6. Adhere the tape to secure the display cable to the system board.
7. Slide the I/O-board cable into the connector on the I/O board and close the latch to secure the cable.
8. Adhere the tape to secure the I/O-board cable to the I/O board.